Aerosoft F-14 Extended Released

Trim issues?

I'm running this in P3D V3, but figured this side gets more traffic.

I reinstalled the Tomcat X and started up on the runway at Fallon. Just wanted to test it out after a long time away.

Anyhow, I noticed I couldnt trim off the nose up attitude of the jet. Flaps were up, wings out, but it still wanted to climb. Swept the wings and same results. Did I miss a switch?

Also, is there a low-viz VF-1 Wolfpack repaint anywhere?

-Jeff
 
Prior to takeoff are your trim gauges by your virtual left knee zeroed out?

For VF1 low vis, maybe a request over at Groom Lake sims on facebook
 
Victory103 said:
Prior to takeoff are your trim gauges by your virtual left knee zeroed out?

For VF1 low vis, maybe a request over at Groom Lake sims on facebook
Click to expand...

Thank you. I'll check that gauge to see. Probably missed that.

And rgr on the FB page. Thanks again.

-Jeff
 
ST0RM said:
I'm running this in P3D V3, but figured this side gets more traffic.

I reinstalled the Tomcat X and started up on the runway at Fallon. Just wanted to test it out after a long time away.

Anyhow, I noticed I couldnt trim off the nose up attitude of the jet. Flaps were up, wings out, but it still wanted to climb. Swept the wings and same results. Did I miss a switch?

Also, is there a low-viz VF-1 Wolfpack repaint anywhere?

-Jeff
Click to expand...

This climb attitude is normal, as the developers stated on the AS forum.
 
You must log in or register to reply here.
Back
Top