• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Aircraft TOT gauge

R

Rhys01

Members +
Hi all


I'm looking for a TOT (turbine outlet temperature) gauge with the analog needle combined with the digital readout. Does anyone know any
freeware aircraft that has one


Cheers


Rhys
 
Looked Everywhere

If you don't understand it at all, ask over at FSDevelopers if someone would help. You can see if Bob Kellogg's email still works too. Though I have some skill, I am not alway very successful when I try to create a gauge and frequently ask for help there as I did last week successfully for help with a gauge. It's worth trying. They are all helpful, great members there. I found the comparison below because I found a set of gauges for you to learn with at Perfect Flight by Bob Kellogg

Exhaust Gas Temperature (EGT), sometimes referred to as Turbine Outlet Temperature (TOT), is the temperature of the turbine exhaust gases as they leave the turbine unit.

Here is your first xml gauge to begin with I found for you at Perfect Flight for you to learn with. Bob Kellogg does a good job of explaining and how to modify it. If it DOESN't work the first time post at FSDevelopers. The README says that I can share with you since we are not selling them: after you get the gauge you want with the proper values, you can ask for help adding the digital readout at FSDeveopers

https://www.mediafire.com/file/zdtm6xx9hc0q7d6/alcor.zip/file
 
You must log in or register to reply here.
Back
Top