• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Ankors Mod CFS3 wont load

garykidman

Charter Member
I have a problem getting ankors shading to work in my install of cfs3. I have an acer monitor with a resolution of 1920x1080 and the settings at the
default settings. as I start to initiate cfs3, it will go in part to the splash screen. and when it gets before the larger splash screen it just bombs out.
Where I am going wrong fellas I am on Windows 7. My WOFF install works fine.
 
That has happened to me a few times when I made a mistake while editing one of the shader files.

The other thing to check that comes up from time to time is needing to rerun the configurator. Make sure the dual pass renderer is turned off and high resolution z buffer is turned on.
 
Ankor Shader

Than you fellas didn't think about the configurator I'll give it a try any other suggestions would be much appreciated.

That has happened to me a few times when I made a mistake while editing one of the shader files.

The other thing to check that comes up from time to time is needing to rerun the configurator. Make sure the dual pass renderer is turned off and high resolution z buffer is turned on.
 
Does your copy of WOFF have Ankor's shaders? It comes standard in 2.0+ but you have to add it yourself if you only are using the original release.
 
shader in WOFF 2

I have WOFF 2 now installed with the shaders but do not know if it will work in cfs3 so i have downloaded earlier version.


Does your copy of WOFF have Ankor's shaders? It comes standard in 2.0+ but you have to add it yourself if you only are using the original release.
 
I recommend the ones from WOFF. They are the best version available and totally compatible with CFS3.
 
Back
Top