• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

another poster suggested I post this here

G

GrizzW

Members +
I want to modify my Beech D-18. I have a Desktop Aviators module that I can interconnect switches and stuff through FSUIPC. I never could get my D-18 to properly "manual" start. Buttons don't seem to work. (only start I can do I Control+E) Is there a proper way to slow spin props using starter and after, say, 8 blades then switch on ignition, add fuel and then have the engine fire off. I really like complex aircraft and would like to modify my D-18 for an accurate start up sequence. Anybody tried something like this before?

I use Win 7-64 and FSX.
Thanks for any response.
Kind Regards,
Grizz Wallace
 
find Milton Shupe's name in 2004 forum and maybe send him a PM..or start a new post with attn: Mr Shupe...unless you are using the other one...simtech?..then tom would be the guy to ask...
 
You must log in or register to reply here.
Back
Top