• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

another question

Daveroo

Daveroo

Members +
i have the sietek switch panel and cessna trim wheel,along with the CP products eclipse yoke and two throttle quads.i plane on a generic fsuipc setup for now,just to get to flying.

first question,can i use the switch panel for four engined AC?..can i go to the batterys "both"..and the use the start "button" to start the engines one at a time? yes i know there are steps to do inside the cockpit too.

and if im using the trim wheel,can i use the "trim wheel" on the eclipses yoke for some other operation?..and an example would be?...remember im just doing the 4 engine simple setup for now..i want to fly now..and detail later.

thanks

Dave
 
You must log in or register to reply here.
Back
Top