Another Windows 10 Problem

[Tom Burnside]

So I have got FS9 working and I was going to install all of my old aircraft such as the JustFlight Lancaster,Vulcan And C-130 but when I put the disc in everything works fine until it goes to set up InstallWizard in which it just shuts down and nothing happens. Has anyone experienced this problem before.

 

[Motormouse]

Try the instructions here; selecting compatibility for WinXP sevice pack 2

---------> http://www.windows10forums.com/articles/compatibility-mode.7/

ttfn

Pete

PS I wont be getting Win10.... wont work with my AMD processor..

 

[Terry]

Try the instructions here; selecting compatibility for WinXP sevice pack 2

---------> http://www.windows10forums.com/articles/compatibility-mode.7/

ttfn

Pete

PS I wont be getting Win10.... wont work with my AMD processor..

My FSX does not work all that well, could Win 8.1 and an AMD processor have something to do with it.

 

[Tom Burnside]

Try the instructions here; selecting compatibility for WinXP sevice pack 2

---------> http://www.windows10forums.com/articles/compatibility-mode.7/

ttfn

Pete

PS I wont be getting Win10.... wont work with my AMD processor..

There on disks when I click properties None of that comes up.

 

[jackryan172]

Try the instructions here; selecting compatibility for WinXP sevice pack 2

---------> http://www.windows10forums.com/articles/compatibility-mode.7/

ttfn

Pete

PS I wont be getting Win10.... wont work with my AMD processor..

Hey Pete,
What processor do you have that wont allow Win 10? I have a couple of AMD machines running Win 10 so far (Im a systems engineer at work) and they seem to be working ok.

Sean

 

[Tom Clayton]

Open the disk to browse the contents, locate the setup file (you may need to open the autorun file to see which one), then set the compatibility mode on that file and run it.

 

[Tom Burnside]

Open the disk to browse the contents, locate the setup file (you may need to open the autorun file to see which one), then set the compatibility mode on that file and run it.

Doesnt work im afraid.