• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

ATC Question

falcon409

falcon409

SOH-CM-2025
This happens from time to time and while I was flying around doing touch n' go's at the New Jersey Airports I'm working on it happened again. When I try to call ahead to make the requested rwy and touch n' go there's no transmission. So when I click the last step, which I believe is "position", I should hear the entire transmission saying something like "Sky Manor Traffic, Cessna 355, 10miles out requesting touch n' go runway 17". However I don't get anything, no matter how many times I click for it to transmit. Has anyone else run into this? Is it an AFCAD problem or does it originate somewhere else? I've checked the Comm/Nav Freq's at all the airports and they are active and correct.
 
What about the AFCAD you are now using? Does it have the proper radio frequencies, etc?

Romeo-Delta
 
falcon409,
This seems similar to the other FSX bug with the ATC window. I can be doing TNG's at a towered field and not have the response in the ATC window after being cleared to land. I have to flip-flop to the standby freq or change one digit on the active for the ATC window to work properly again. Your freq's for your new AFCAD's are labeled CTAF or Unicom?
 
You must log in or register to reply here.
Back
Top