Avtek 400

falcon409

falcon409

Moderator
Staff member
I'm running low on patience with flightsim.com right now. If anyone has the full file and can send it to me, I'd appreciate it. Or, at the very least, if someone could send me the texture that contains the VC, I could start working on enhancing the bmp.

ejwells409@cableone.net
 
Great Flyboy, got it already and a thanks also to Dandog for sending it on as well. Much appreciated guys.:salute::salute:
 
Weeeeeeeeeelllllllllll Falcon, whats the word in this one from your point of view. Havent had achance to load and fly it yet. Too much other c**p needs to get done.
 
I've done a new paint job using the paint kit I made up for the Avtek and I'm also working on the VC bitmaps.
Has anyone else noticed a real problem with this airplane being very, very nose heavy? I added a bit of nose trim on take off, but had to steadily increase that to even get the airplane to lift off and then had to continue adding nose up trim to keep it from diving. I finally gave up.

I checked the fuel and payload numbers and saw nothing there (quantity-wise) initially, but It did look like the cg was was farther forward than I would expect. Not sure if that's it, but I don't know how to correct that so I left it alone.:salute:
 
. . . . .and here's the "in sim" panel. For those who aren't aware of this, I noticed that initially the gauges were very fuzzy. I assume Ito San sets the gauges at a low-res so that anyone can run his panels without worry about extra resources to run a higher res. You can change that by going into the panel.cfg file, scroll to the vc-cockpit sections and changing the pixel size=512,512s to 1024, 1024s.
 
You must log in or register to reply here.
Back
Top