• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Breguet 693 & 695

Collin said:
Do you see those polys on the tailplane that have a shadow in a corner or the flight controls on the main wings with similar problems? Just alter the poly smoothing number and you will see what I was talking about earlier.

So how are you trying to make the LOD models?

regards Collin:ernae:
Click to expand...

Collin,
This is a problem I have at several models in my install.
Can this be fixed, once the mdl was compiled?

regards,
Michael
 
Jaxon said:
Collin,
This is a problem I have at several models in my install.
Can this be fixed, once the mdl was compiled?

regards,
Michael
Click to expand...

Michael, I'm not 100percent on this but I would say no.
Its one of those things that has to be fixed within model before its compiled. Even in fsds you don't know about it unless you go into poly-mode. The compilation will be of the parts and its the info within the parts that makes the polys look different, this bit is lost in the mdl, (something like the Mission Builder inside the cfs2.exe.....). Its there, but you can't grab the sucker.

regards Collin:ernae:
 
Can this be fixed, once the mdl was compiled?
Click to expand...
If you are talking about LOD models, If you can construct separate LOD models in FSDS and export scasm source for each. Then hacking them all together at the scasm level is possible.
If it is smoothing problems, then you are looking to adjust parameters for maybe a single vertex in a list of 20000. Not impossible but...
 
:salute:This is a very interesting thread. PC Pilot magazine had a tutorial on how to start with FSDS, in 2 issues, I believe. I may have these issues, and will look.

Thanks to all,

Nick
 
You must log in or register to reply here.
Back
Top