I just loaded the 340 and it looks good but I am having trouble with the throttle and propeller controls. When I increase sensitivity to get Full manifold pressure the manifold pressure goes from max to min with the throttle movement on the CH controller of only about a one hundreth of an inch. If I decrease the sensitivity to get Throttle response with movement, then I get limited range of manifold pressure (ie no full throttle and can't shut down). The same issue is present with the propeller control. Is this a CH issue? I am running 2004, would upgrading help? Is it correctable by me somehow? What next?
-
There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.
If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.
Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.
The Staff of SOH
Cessna 340-CH controler Issues
- Thread starter Gennaro
- Start date