P
pjmac35
Guest
Haven't played this for a while and now can't see target cone or get padlock.
Any ideas?
Regards
Pat Macguire
Any ideas?
Regards
Pat Macguire
Hopefully its a simple matter. Make sure you go through your "controller" list and double check
your function buttons. Your target cone at default should be "tab" and Shift-Tab to cycle back.
At the moment I dont remember what padlock was. If that doesnt do it, you may have to uninstall
and just reload the game. Hope you dont have to do that though.
Good-luck and welcome back to CFS3!
your function buttons. Your target cone at default should be "tab" and Shift-Tab to cycle back.
At the moment I dont remember what padlock was. If that doesnt do it, you may have to uninstall
and just reload the game. Hope you dont have to do that though.
Good-luck and welcome back to CFS3!
P
pjmac35
Guest
Thanks for taking the time, but does this sound familiar? You struggle for days with a problem then finally resort to the Forum. Very next time you start the sim you arrive at the answer!!! So embarassing! I had forgotten to Select Target first by pressing "Tab" And, yes, I did reinstall it! What fun!
Actually, after a long absence and dalliance with IL-2, I must say I thought CFS3 was very good.
Thanks again
Pat Macguire
Actually, after a long absence and dalliance with IL-2, I must say I thought CFS3 was very good.
Thanks again
Pat Macguire
grizzly50
Charter Member
Pjmac35, to toggle the targeting indicators on/off in-game is: Ctrl + Shift + I (the letter "I").After the indicators are up, you can target the cone itself on/off by just using I (the letter "I").
The TAC screen is toggled on/off by using Shift + T.
The TAC can further modified to show aircraft only, ships only, vehicles onl, etc, simply by pressing T to cycle through the various TAC screen subjects.
The damage test that comes down the screen as things happen can be toggled on/off by Shift + D.:d