• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

CH yoke setup for X-Plane

AussieMan

AussieMan

SOH Staff .."Bartender"
A little while ago I read an article on setting up your CH yoke for use in XP11. I even downloaded the file with the setup. However after printing it out I seem to have lost both the printout and the downloaded file. Is there any chance of being pointed in the right direction of finding the file again please.
 
Sorry, I will not be of much use. I have not ran into such file.

I use the CH Yoke, as well as the rudder pedals and throttle quadrant from CH Products. I have them set up myself, for use with different airplanes.

It is really not that hard.
 
does it not show up in the setup page?,if so it really is pretty easy to set up,or should be,much easier than FSX or P3D for me.and im pretty stupid anymore. :playful:
 
You must log in or register to reply here.
Back
Top