• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

Dodosim 206 Bell Canadian WIP

B

BananaBob

Guest
Should finish this up today, was a request.

heloreq1.jpg
 
Ewww pretty!

I really need to buy the Dodosim 206! I havent yet, just so little time to fly.
 
Bob, I have a question.
I installed as per instructions. I do not see the paint when looking at the outside...just the ones that came w/purchase. What am I missing?
 
Did you copy the 4 folders to your Rotorcraft folder and overwrite when asked? Then you have to copy what's in the text file in each of those folders to 4 different cfg files for the different models. I know, it's a royal pain, but that's the way it's setup. Let me know if you need any more help.
 
If anyone else is having problems let me know, I'm horrible with the instructions, I know, LOL. :ernae:
 
the only one that shows up is the low skid. I looked in the texture folder and there are bitmaps & stuff that are not there in the other texture folder for each types...
Is that possibly the answer? cause I did what ya said.
 
the only one that shows up is the low skid. I looked in the texture folder and there are bitmaps & stuff that are not there in the other texture folder for each types...
Is that possibly the answer? cause I did what ya said.

Each of the 4 models has it's own aircraft.cfg file, so it sounds like you only pasted the low skid one into the that particular aircraft.cfg file. Did you change xx to next number after pasting? I'm trying to figure out what's happening.

You'll have 4 of these to do, this one in the pic below is for the "utility" version, it will say it at the top of this text file. You'll have to copy the highlighted part to your Utility aircraft.cfg file.

dtp1.jpg



now you have to replace the xx with the next numbers, mine are 4 and 5. This has to be done 4 times, the utility, lowskid, highskid, and float versions. Each folder of mine has the part you need to paste. Hope this helps.

dtp2.jpg
 
Yes...that I did.
I just figured out what I had to do to get the others to show. I copied the textures from the low skid cgpgx folder to all the other cgpgx folder for the other types...high skid,utility and so on. Works like a charm. Awesome paint work. I see the interior textures are a little different too. Kewl!
I hope that helps you know what I did.
 
Back
Top