• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Does anyone know what causes this panel problem...

Try just grabbing the runway and pulling it down...As to why it loaded like that I don't know....Sorry
 
It is the windowsize, I know it is somewhere in your panel.cfg but I do not know what has to be changed. The designer did it this way so your panel will not block your forward view.
 
Had a similar problem like that. Is it happening to just this add-on aircraft or all. Not the default aircraft. If happening to all, you have your anti-aliasing on in FS and your video settings. Turn off the one in FS. It cleared up my problem. Once I get my settings right in FS and on the video card I take screen shots of each section, so if I muck about with it and screw it up I can put it back right. I did have one aircraft, that for some ungodly reason changed my settings. Nothing worked until I removed it.
Best I can tell you at the moment

BR
Derek
 
In the panel.cfg, find this part:

[Default View]
X=0
Y=0
SIZE_X=8191
SIZE_Y=6000

Change the SIZE_Y to some larger number than it's currently set to...
 
That is usually caused by the window size being set too shallow. At the bottom of most panel.cfg files you will find something like this:

[Default View]
X=0
Y=0
SIZE_X=8191 <====determines how wide the window is
SIZE_Y=6143 <====determines how tall the window is



OBIO
 
PRB, Obio,

There was no default view in the panel.cgf. There is now. Problem fixed.

Thanks, guys.



Geary
 
You must log in or register to reply here.
Back
Top