• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

DPC Korea Splash Screen on launch then Nothing

J

JackMorris

Members +
Hey all!

Just installed Dogpatch's Korea mod from the links here at the forum...

Before you ask... yes I have a CFS3 Virgin Install patched to 3.1a that I switched to before beginning install.

Firstly I installed the base mod... worked a treat... all directories perfectly set in installs to make they are correct etc. and booted up just great, changed the first airfield for quick combat and it all worked!

Then I installed the first patch being careful to follow instructions... Made sure the config was in safe mode and everything, but when I booted it it just showed the splash screen then the splash screen disappeared. Cannot get any further.

Tried also installing the third patch on top of it, but same problem.

Weird, right? Wonder if anyone else has had this issue, and hope there is a quick fix!

Many thanks for any replies!

All the best,

Jack
 
UPDATE - I solved the issue... (call me out for being dumb :p87:)

It was to do with my compatibility settings... (I'm on windows 10 64 bit...) Changed it to XP Service Pack 2 in Properties>Compatibility and it's working a treat :)

Compatibility settings are usually the first thing I check, however since I can run ETO in standard mode, along with vanilla CFS3, I didn't think this would be any different... turns out I was in mistake.

I won't delete this thread, instead I'll leave it here in-case anyone googles the same thing in future and needs a quick solution!
 
You must log in or register to reply here.
Back
Top