• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Engine sound problem

H

hamis

Members +
What could be wrong with my install of cfs3,engine sounds start to respond when throttle is about 50%?
 
It's not unknown for CFS3 to need a quick 'blip' of the throttle to 100% and back down again before it responds properly. Also check your throttle's calibration in the joystick calibration thingy.
 
Hi hamis,

in the options settings theres sliders for 4 or 5 differant sound items. one of them is aircraft engines, have you checked to see if any of the sliders are set low?

regards Rob.
 
I don't see anything terribly abnormal, though most CFS3 aircraft don't model very low power settings very well. If you want to change it, there are various add on sounds available in the download section here. Also sound sets for any other the other MS flight sims will work in CFS3. If you still want to tweak things, follow the directions in the last post of this thread. http://www.sim-outhouse.com/sohforums/showthread.php?40606-Projected-knowledge-base/page3

Hope that helps.
 
You must log in or register to reply here.
Back
Top