• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

F-111 in V4.5

brettt777 said:
Is there a good F-111 that works in P3D V4.5?
Click to expand...

Funny you would mention this...I was thinking about it just this past week. It appears that Just Flight’s version works with P3D, although I don’t know about v4.5. The only other F-111 I know of that **might** be compatible with P3D “out of the box” might be Virtavia’s FSX F-111.

What I REALLY miss is Gold Key Simulations F-111. I’ve never had success porting it to P3D, but it (to me) was the most realistic F-111 out there.

Finally, I’m not aware of any new F-111s being developed for P3D.

Hope that helps a bit.

Kent
 
I would think the Virtavia one might since it used xml coded gauges.
That often seemed to be the issue -- gauges based on 32-bit code.
:ernaehrung004:
 
I wish GKS wuld update it but I'm not holding my breath on that. I am also hoping Captain Sim does the same with the B-52H soon.
 
StormILM said:
I wish GKS wuld update it but I'm not holding my breath on that. I am also hoping Captain Sim does the same with the B-52H soon.
Click to expand...

I found the arm load gauge caused my CTDs, you could remove that dll and create static load models but ive never had the time to experiment

GKS has shutdown their page and forums so i guess you can say a 1 release and close team
 
jeansy said:
I found the arm load gauge caused my CTDs, you could remove that dll and create static load models but ive never had the time to experiment

GKS has shutdown their page and forums so i guess you can say a 1 release and close team
Click to expand...

I'll have to look at that later when I have time. Right now with the holiday schedule and just getting my PC back up and running, I don't have P3Dv4.5 fully up and tuned in yet.
 
You must log in or register to reply here.
Back
Top