• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

FSX COP3 Carrier launch problem

PhantomTweak said:
Well, I see one problem.
The COP3 stuff is all in pop-up, 2D panels. Unless you open them manually, I don't see any way to call them, and unless they are opened, the gauges never load.

I don't know if this is correct or not. I always put the COP stuff in FS9 in the VC, s they would load automagically.

Maybe this could have a bearing on it all?
Pat☺
Click to expand...
No, it doesn't.
Window17 is auto-opened by the gauges
gauge85=COP3/WindowStatus!window_status, 0,0
gauge86=COP3!WindowInit10080,0,0​
in the Vcockpit01 section.

And that Window17 IS opened correctly, otherwise he wouldn't hear the catapult launch sound ..;)

Rob
 
@"Marine0326",

I don't see any problem with your panel.cfg or config_lear.ini.

But what's new is, that you state that occasionally the Catapult launch DOES work.

Which really is a mistery to me; maybe your test with the alternative IPC module (from the F35) sheds some light.

Another thing:
I see that you also use the RFN package in your panel.cfg.
There is a gauge named
gauge82=RFN_CarrierGauge!CustomCatapult, 0, 0,

I don't have a clue what that gauge does. Maybe there's a conflict with my COP3 Catapult.xml gauge ??

Rob
​
 
rcbarend said:
@"Marine0326",

I don't see any problem with your panel.cfg or config_lear.ini.

But what's new is, that you state that occasionally the Catapult launch DOES work.

Which really is a mistery to me; maybe your test with the alternative IPC module (from the F35) sheds some light.

Another thing:
I see that you also use the RFN package in your panel.cfg.
There is a gauge named
gauge82=RFN_CarrierGauge!CustomCatapult, 0, 0,

I don't have a clue what that gauge does. Maybe there's a conflict with my COP3 Catapult.xml gauge ??

Rob
​
Click to expand...

Rob,

I''ll shut down (//) that "gauge82" and see what happens. My other PC runs COP3 just fine on several aircraft. On this new one, the Lear is the only I've tested to make sure all was good. I'll have to check the other PC to see if I have the RFN installed on the same COP3 planes.

Thanks again!!
 
You must log in or register to reply here.
Back
Top