FSX / P3Dv3, v4 Vought Corsair Early F4U-2.zip

[afscrub]

A new entry has been added to Add-Ons Library, category P3D / P4D Add-Ons - Military aircraft

Description: FSX / P3Dv3, v4 Vought Corsair Early F4U-2

The Corsair entered service in 1942. Although designed as a carrier fighter, initial operation from carrier decks proved to be troublesome. Its low-speed handling was tricky. Landing a Corsair on a carrier was a difficult task. For these reasons, most Corsairs initially went to Marine Corps squadrons which operated off land-based runways. The U.S. Navy did not get into combat with the type until September 1943.

Standard and Nightfighter version included. Native FSX / P3Dv3 ,v4 mdl by A.F.Scrub.

To check it out, rate it or add comments, visit FSX / P3Dv3, v4 Vought Corsair Early F4U-2.zip
The comments you make there will appear in the posts below.

 

[Roxane-21]

Hmmm... There should be only 2 .50 on the right wing.

 

[K5083]

Still, it's a nice model. I like the handling, feels quite similar to the Milviz but with a little less torque.

Neither of the provided textures is of an F4U-2 night fighter; both are of F4U-1s. Skins for the old FS2004 Aeroplane Heaven Corsairs fit this model, but I haven't found any -2 skins yet.

August