• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

GAS Stampe SV-4B for FSX FSX SE and P3D

Dumonceau said:
And this is what it looks like in P3D v2.5

Stampe.jpg


Just one small glitch, the installer points to prepar3D and not to Prepar3d v2. No biggie though!

Thanks for this gem Spad!

Johan
Click to expand...

You're welcome Johan. It was a fun project especially because of the engagement of the SOH members as it progressed. As for the installer, that was intentional and not sure who has what version of P3D therefore the owner has to make that last navigation.
 
Dumonceau said:
Spad,

Thanks for your pm. That is highly appreciated. I've taken the liberty to spread the word about this among my little part of the Belgian simming community.

Standby for quite a few sales with email addy's that end with .be! A lot of the boys are quite excited about this release. Especially those who learned to fly RW on the SV-4B in the BAF!

Take care,

Johan
Click to expand...

Thanks for the referral. Much appreciated:ernaehrung004:
 
I really like my Stampe too...
all kinds of pilot movement in the pit :applause:

Thank you :ernaehrung004:

attachment.php
attachment.php
 

Attachments

  • 2015-5-30_8-7-11-421.jpg
    2015-5-30_8-7-11-421.jpg
    31.9 KB · Views: 3
  • 2015-5-30_8-5-37-634.jpg
    2015-5-30_8-5-37-634.jpg
    39 KB · Views: 3
I really like the flight dynamics in this plane. Never flown one but they are believable. I like the way it stalls, spins and recovers from a spin. Tried also landing using different approach angles and speeds on a grass field and had a blast. Well done!

Minor grunt (applicable to all GAS creations I have so far): Internal texturing is a bit blunt. Not so important for an open cockpit biplane like the Stampe but it is a point where there is room for improvement in your creations imho and will add to the immersion of flying these classics.

Keep up the good work!
 
Dimus said:
I really like the flight dynamics in this plane. Never flown one but they are believable. I like the way it stalls, spins and recovers from a spin. Tried also landing using different approach angles and speeds on a grass field and had a blast. Well done!

Minor grunt (applicable to all GAS creations I have so far): Internal texturing is a bit blunt. Not so important for an open cockpit biplane like the Stampe but it is a point where there is room for improvement in your creations imho and will add to the immersion of flying these classics.

Keep up the good work!
Click to expand...

Thanks for the comment. We've had discussions around just that and expect more detailed textures in the future.
 
Hi Johan
I purchased as soon as your first post went up for the stampe offer,paid by PayPal and all is fine but I do not have the two patches.
Any chance of a link to them.
Cheers Chris

original purchase 26 May
 
You must log in or register to reply here.
Back
Top