• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

IRIS F-14 Launch Nose Gear Problem

Wings of Gold

Wings of Gold

Charter Member
I have started taking my IRIS F-14 out to the USS Nimitz. I added the standard [Launch Assistance] paragraph in the aircraft.cfg file, so that I can use the Acceleration Catapult launchs. It (like the rest of my carrier aircraft) does work - however (in the IRIS F-14's case) the addition of the launch assistance paragraph also results in the lower portion of the nose gear no longer retracting. The rest of the landing gear retracts (including the upper portion of the nose gear). If I do NOT add the launch assistance paragraph, the nose gear retracts normally. Is there any known fix to this problem? Pam??

Bill
 
Try hitting either Shift/I or Shift/U after launch.
One of those (I forget which) is the default key to retract the launch bar.
 
cannot check my desktop pc which has FSX on it just now I recall the manual has statements about using the VC switch to lower the nose for cat launch I could be wrong so I'll check later
 
I believe that the cat works correctly without the Launch Assist entry in the cfg file. Adding it is probably causing a conflict with code in the model. I have done cat launches and do not have it in my cfg. One note of caution, the wheels will not retract with the cat launch bar down so you have to retract it then put the wheels up as I remember.

Dave
 
I never added anything to the Cfg file to make it "compatible" with the Accel carriers. I have used it off of them and don't recall any problems. HOWEVER, I cannot retract my gear after launching from a carrier if I don't reverse the setup procedure. It is as if when you "lock" the gear to the catapult, the gear "locks" down and wont retract until I hit Shift + U a second time. Then the gear works fine, retracts, and I am hitting the gas to gain altitude.

I hope your problem is as simple as this.
 
The iris Tomcat works fine with carriers without editing the config file. That's what causes a conflict I think. On non-iris aircrafts I have to retract the launch bar first (shift+u)
 
You must log in or register to reply here.
Back
Top