Quicker start with screenies.
Think you'll find the startup is coded along with other gauges so you can't shortcut it; however;
here's a slightly quicker way to do it, you need to be in 2d panel view
1) Start flight using default Cessna; switch all avionics etc on
2) Swap plane to the G91, the engine
will quit after a few moments :isadizzy: so....wait until it does then--->
3) In 2d panel, open the throttle window and select fuel lever to open (fuly forward); then close throttle panel
next, open starter panel, switch on ignition and fuel boost pump, select fuel system to normal (light out),
then open cover over starter button, press starter once.
View attachment 63604
View attachment 63608View attachment 63607View attachment 63606View attachment 63605
You should hear 'bang' as starter fires, then engine will startup, spool-up is quite long so wait.
4) Switch 'on' elevator servo hydraulics,check gauge, switch 'on' 2nd inverter, check light out, and fuel transfer, light on, check gauge.
5) for T/O select one notch of flaps, plenty of 'up' trim; set engine at 90% rpm (it will quit if held above for a long time), get airborne @ 110kts, then put gear and flaps up toute-suite or they will break too.
All in all its a bit like the Section F8 Sabre in its handling. Have fun
ttfn
Pete
Edit:
hmm somehow screenies didn't end up where I wanted them, another forum bug I guess, but they are named in sequence 1 thru 5
hope this helps