• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

Lost Tool Tips ?

IanHenry

IanHenry

Charter Member
I seem to have a small problem, in that the “tool tips” (at least I think that’s what they are called) which gives you the readings of gauges and the names of switches when you roll the mouse cursor over them have disappeared.
Maybe the answer is obvious and I’m missing something really simple, but if anyone can make any suggestions as to how to rectify this problem I would much appreciate it.
<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:eek:ffice:eek:ffice" /><o:p> </o:p>
Regards,
Ian.
 
Thanks for your replies,<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:eek:ffice:eek:ffice" /><o:p></o:p>
Yes I am using DX9 Kilo Delta. Papab, where in settings is that option? I can find “Display Flying Tip” in the options section, but that’s the one that keeps scrolling irritating messages across the top of the screen, and not allowing me to use the mouse pointer to read gauges etc.
<o:p> </o:p>
Thanks,
Ian.
 
i belive its under the settings - display - aircraft bit on the left hand side under the slider where you set the 2d transparency :)
 
Thanks Stiz, that’s sorted it. That must be the only place that I missed looking at!
Regards,
Ian.<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:eek:ffice:eek:ffice" /><o:p></o:p>
 
You must log in or register to reply here.
Back
Top