• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

M Jahns C47 Dakota for CFS 2 UT

UncleTgt said:
Thanks for the offer Braveheart, but you can work on it better yourself. The issue for me is the VC gauges.

I simply used cfgedit to put CFS2 gauges into the 2D & VC panel entries. Whilst doing this, I found the vc positioning difficult to fathom, it seems to repeat gauges in different locations.

I don't know if the VC panel locations were messed up during the conversion, but I struggled to get a set of VC instruments that looked good. I hope you can improve on it - please upload if you succeed.:jump:
Click to expand...

Doing vc gauges for me is enough too make me throw the computer out the window!!! Lol
 
Reply...

UncleTgt,

Thank you and to Manfred Jahn for bringing this wonderful plane into the CFS2 community. :encouragement:
 
You must log in or register to reply here.
Back
Top