• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

Mooney Mite Radio Stack

falcon409

falcon409

SOH-CM-2025
I seem to remember this being a problem on another of Tim's airplanes and now I see it on the Mite. In the VC, the frequencies show on the Comm/Nav_Transponder and DME, but I can't swap the Active Nav freq.

I tried swapping out radios in FSPanel Studio, but they seem to be hardcoded because when I went back to the sim, the same radios were still in place but I could see the new ones behind them. Anyone aware of a fix for this?
 
Here is the radios section of the aircraft.cfg for the A-1H. The red numbers specify whether or not the nav radios have a stanby freq feature. If these numbers are zero, as they are here, and you put in a radio gauge that has a stanby freq capability, you won't be able to swap feqs. That's what I would check first, and set to 1 and see what happens.

[Radios]
Audio.1=1
Com.1=1,0
Com.2=1,0
Nav.1=1,0,1
Nav.2=1,0,1
Adf.1=1,0
Adf.2=0,0
Transponder.1=1
Marker.1=1
 
Thanks Paul, I had already looked at that and everything was fine. It's kinda weird cause the radio's in the VC look like poor bmp's with the numbers window the only active part of the radio and I can only change the standby freq, but then there's no way to swap. . .even the keystroke for changing the freq's has no effect. Also, completely removing and replacing the radios in FSPanel Studio has no effect because when I reload the aircraft, the same old radio faces are showing, that's why I made the statement in my initial post that it looked as though the radio was hard coded in the model.

Maybe Tim will chime in here sometime or someone who has the Mite and surely must have the same problem. . .unless there was a fix that isn't posted!!!!:salute:

Thanks again Paul!
 
Duh, what's a radio? :icon_lol:

Seriously, I am terrible, I will use a GPS, but a radio, I am not fitting!

My brother uses them all the time when he sims here, but he's usually flying a twin like the Baron or LH's Viking. I shall look into it, however.

Caz
 
You must log in or register to reply here.
Back
Top