Cazzie
SOH-CM-2024
Manuele, it is so lovely, last night I finally had time to fly her. I hope you do not mind, but I did a few changes to mine. I made a new propwash, that is not that much different from your wash, except for adding a very transparent disk and showing the blade logo in the spinning prop also. I did noticed that the wash was static (stayed in one place) when at set rpms. To change this, I used a little trick I learned from Francois. In the Aircraft.cfg, add the following line below each aircraft after the last ui=???????: prop_anim_ratio=1.025.
I also cleaned up the vc glass and gave it a bluish tint to match the outside appearance.
The textures are attached in the .zip. Open the .zip and place the textures in each of manuele's C205 textures and overwrite if you approve. Adding the "prop_anim_ratio=1.025" to the Aircraft.cfg as mentioned, will improve the spin.
Old prop wash
New prop wash
Old VC glass
New VC glass
I also cleaned up the vc glass and gave it a bluish tint to match the outside appearance.
The textures are attached in the .zip. Open the .zip and place the textures in each of manuele's C205 textures and overwrite if you approve. Adding the "prop_anim_ratio=1.025" to the Aircraft.cfg as mentioned, will improve the spin.
Old prop wash
New prop wash
Old VC glass
New VC glass
