• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

P3D V3.2 update

AussieMan

AussieMan

SOH Staff .."Bartender"
I downloaded Prepar3D_v3_Academic_3.2.3.16769 today and I am wondering if I have to uninstall the complete P3D V2.2 or just uninstall the P3D Client to install the upgrade.
 
V2.x and V3.x are different sims, so you can have both installed at the same time. It's NOT an upgrade for V2.x
 
I think you can start with the client and if you encounter problems you can update other components. As far as I know you don't damage anything if you start with the client first.
 
Best to do both "client" and "content" otherwise you'll get issues with some add-ons that use in-sim menus such as AI Carriers.
 
I have just done the Client for now. Nice to see the Selection Menu is back. Can now use commands like ALT+E+S for vehicle selection or ALT+W+A for airport selection.
 
Unfortunately the problem with the CH Yokes and pedals has not been rectified. It shows "CH Yoke" in the Controls panel but it still doesn't read the input from the levers. Still have to set things up in FSUIPC.
 
I also use the CH products and I do not have the issue you describe. My yoke and pedals work flawlessly.
 
Rimshot said:
I also use the CH products and I do not have the issue you describe. My yoke and pedals work flawlessly.
Click to expand...

Be interesting to know how you got it to work. I have them working using FSUIPC but would be interested in how you got them to work by default.

There is quite a big forum topic on this running on the LM site.
 
I didn't do anything special to get my yoke to work Pat. After a clean install of P3D 3.2 the calibration menu in the sim recognized all axes without any issues. I even stopped using FSUIPC. I have no idea what's going on at your end. Wish I could help...
 
You must log in or register to reply here.
Back
Top