• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Problem with 727 panel

F

francois203

Guest
Hi,
I have the wonderful 727 panel of Richard Probst. However, i have one problem. I use it with the 727 of Eric Cantu and the cargo door of the 722F model doesn't open when I hit the ctrl+E+2 keys while it works perfectly when I remove the panel. does anyone know why?
François
 
I've had that issue with other plane/panel combo's, and I finally traced it down to a gauge that was constantly polling the system. It kept any exit other than #1 from operating. Once I deleted that offending gauge, all the exits worked fine again.

Have you tried Ken Mitchell's 727 panel? Look for b7272pnl.zip on Flightsim.com.
 
I can't check right now cause my video card died, but have you tried either the tailhook or wing fold command ( Shift T or Shift F on my system )

Several of my aircraft use those.

Pete.
 
francois203 said:
Which gauge was concerned?
Click to expand...
It was a completely different plane and panel (Mike Stone B314 w/ the Ken Mitchell panel). I found it through FSUIPC's log function. Turn on the logging for about 15 seconds. When you read the log file, you'll probably find some variable that's repeatedly either being polled or set at a rapid-fire rate. Then it's down to old-fashioned detective work to figure out which gauge is causing the problem.
 
You must log in or register to reply here.
Back
Top