Problem with outside view on Manfreds new DC3.v3 and EZCA

ejoiner

ejoiner

Charter Member
Hi guys. I have a wierd problem with Mandreds new C47v3. Using Ezdok for both internal and external viewing, I have no problem at all in the cockpit using my created EZCA ecs file for viewing. However, when I go to the external view also using Ezdok, only the interior model of the C47 is shown. I get the cockpit box and two wings. No fuselage.

Using standard "S" view, I can see everything fine. Only when using Ezdok in external view do I have a problem. I dont have this issue with any of my other airplanes AND interestingly, I do not have this issue with Manfreds previous v2 C-47 using exactly the same ECS profile.

Anybody else with this issue or suggested cure?
 
Try running the EZDOK Config.exe, even if you have already run it. I noticed that the new release I had to run it twice, but I do get a good exterior set of cameras with this model.
 
You must log in or register to reply here.
Back
Top