• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

RCS B-25 Bomb Bay Doors

Josh Patterson

Josh Patterson

SOH-CM-2023
Hello all, I'm looking for some pointers here. I am running Roy Chaffin's B-25 in FSX and have a problem with the bomb bay doors. They are operated by the water rudder key but the animation is non-existent. They go from full closed to full open visual condition with no animation in between. I tried lengthening the retraction and extension time for the water rudders in the contact points section of the CFG. No go. I then imported it into MCX and saw a spot in the animation where the doors get about halfway, close a bit then continue to the full open position. There was a number out of sequence at point 72 on the animation key editor, so I fixed it and got it to where I no longer got the "quaternion not normalized" warning. I exported it and now the water rudder/bomb bay door animation works but my main gear are out of position, being about 70% retracted with part of the strut in a goofy position (although the contact point is in place as the plane sits fine on the ground). I tried a second run where I merely changed the animation title in the hierarchy editor from 'lever_water_rudder" to "l_spoiler key" and "r_spoiler_key" which had the bay doors working off of my spoiler button (complete with a dip in the animation due to the out of sequence number) but something is happening during export that causes the main gear to go wonky. (Also the entry ladders appear on the exterior of the aircraft in both cases.)
 
Last edited:
There must have gone something wrong with the conversion, as the FS2004 version has an animated sequence for the bomb bay doors.

Cheers,
Huub
 
huub vink said:
There must have gone something wrong with the conversion, as the FS2004 version has an animated sequence for the bomb bay doors.

Cheers,
Huub
Click to expand...
Yeah Huub. I used to run the 2004 in FSX before the conversion and they did work. As an aside, the solid nose version of Milton's A-26 does this too but for some reason the glass nose has normal bomb bay animation. (Or maybe it's the other way around.) As I said, I did get them to work but it affected the main gear display and animation. Is this a common problem during conversions? Is there anything I can do about it other than go back to the 2004 version? (And IF I do get it to work, would it be okay to post the modified MDL file? I'd ask permission but from what I've read Roy is tough to get a hold of.)

I am still quite new to MCX (and WAY behind the curve for FS2020). There are a couple of planes I'd like to build but I'm still having trouble tackling this stuff.
 
Hello,

I am running Roy Chaffin's B-25 in FSX

I suppose you know ...... RIP

Code: 
https://www.watfordobserver.co.uk/memorials/death-notices/death/30544224.roy-chaffin/
 
Homage to Roy...

OUFme7R.jpg
 
You must log in or register to reply here.
Back
Top