• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Same old weird display error

TARPSBird

TARPSBird

Moderator
Staff member
After reading Gedm's post about saving old CFS2 how-to posts, I have this :censored: problem again. Was selecting an aircraft for Free Flight, got error message saying "CFS2 has caused an error in unknown, CFS2 will now close" and when I start it up again I get this tiled effect on scenery and aircraft (see pic). I seem to recall there was a correction for this but don't remember what it was. I tried deleting the cfs2.cfg file but that just causes the sim to create a new .cfg and I still have the display problem. I don't want to create a System Restore point before each CFS2 session. :mad: Any suggestions would be appreciated, if there's a correction I'll file it away this time.
 
Go into Settings and check your hardware and video settings. Looks like they may have been reverted to the default settings. Up the resolution and detail settings in your sim to higher levels.

OBIO
 
Obio, thanks for your reply. My hardware and video settings showed no change from what I normally have them at, but I will watch for that if it happens again. I ended up rebooting the computer and that resolved the problem.
 
I had a similar problem.....

....last year. It turned out to be a corrupted stock scenery file. I corrected it by replacing the stock scenery files with copies from my stock install on the same hard-drive. You might be experiencing the same type of problem.:wavey:
 
corrupted files

TR;
this may fall in your area, or Ramis', If you have the SdC scenery installed and then put in Pen32's 2TAF scenery would there be a problem? I have them in and when I go to fly Interlaken I get the Fjord but the hills ahve no texture and are pea green. as I fly away some parts of the area take on texture but not all. I forget the actual terminolgy name for this effect.
Still trying to rebuild my ETO theater.
 
The only way to tell....

Fibber said:
TR;
this may fall in your area, or Ramis', If you have the SdC scenery installed and then put in Pen32's 2TAF scenery would there be a problem? I have them in and when I go to fly Interlaken I get the Fjord but the hills ahve no texture and are pea green. as I fly away some parts of the area take on texture but not all. I forget the actual terminolgy name for this effect.
Still trying to rebuild my ETO theater.
Click to expand...

...for sure is to remove or deactivate one or the other. Sorry, but that's the best I can offer.
 
You must log in or register to reply here.
Back
Top