• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

stupid trees

J

jackryan172

SOH-CM-2025
Hi All,

I was flying from NAS Key West, to NAS Pensacola and on arrival I have found no place to land. The runway was overrun with trees along with the ramps and taxiways as well. Is there an exclude or something to make the trees go away? Is there some tool that do define the flatten area? Is Flatten the right word?

Sean
 
Do a little search for these two "FST Flatten" , flatten area utility, and "EXC Builder" exclude file builder, both do what they say on the tin so to speak.

ttfn

Pete
 
You may also use Airport Design Editor (ADE9), use it to open the airports AFCAD, slew your aircraft to any offending growth and make an exclude box for that location. You then save the new afcad into the same folder and cut and paste the old one to that scenery's main folder so FS won't load it, in case you want to switch them back. If the trees won't go away, they must be getting placed by another addon scenery and will have to be tracked down for removal from that folder.
 
And while you get ready to learn those new tools, you might turn down the autogen density slider a notch. That might or might not help, but it just takes a few seconds to try it.

Go to Settings, Display, and on the right you'll see (among other things) the slider to adjust autogen density.
 
its weird, its maiw scenery and I never have problems with then (well almost never, Nellis AFB messed up my NAS Fallon install but that was along time ago). Im going to try building an exclude bgl tonight and Ill let you know.

Sean
 
You must log in or register to reply here.
Back
Top