Noticed an unreal amount of air to air collisions with OH TBD's en route to target.Noticed setting airspeed below 140 tends to cause more problems for some reason. Problem is even with speed set to 140 knots(pushing it for cruise speed for TBD) they do this strange thing where suddenly begin weaving like crazy when in formation, and eventually run into one another. Sometimes they dont collide, fly normal then do it again.I remember had this issue with G4M's(both AI flights and player AI player wingmen) when making flights in real time, someone corrected it(Rami?), believe it was something in the mdl file or cfg, been a while back and do not recall but would be useful for my midway and coral sea missions.Losing so many TBD's to air to air collisions, screws up the mission in many ways. Lost 6 of 12 TBD's in a formation this way.Any help is appreciated.
-
There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.
If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.
Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.
The Staff of SOH
TBD troubles
- Thread starter dasuto247
- Start date
The B24 Guy
SOH-CM-2022
Hi Dasuto,
Try these changes to the cfg. file.
[flight_tuning]
cruise_lift_scalar = 1.0
parasite_drag_scalar = 1.0
induced_drag_scalar = 1.0
elevator_effectiveness = 1.0
aileron_effectiveness = 1.2
rudder_effectiveness = 1.0
pitch_stability = 0.8
roll_stability = 0.6
yaw_stability = 1.0
elevator_trim_effectiveness = 1.0
aileron_trim_effectiveness = 1.0
rudder_trim_effectiveness = 1.0
Regards,
B24Guy
Try these changes to the cfg. file.
[flight_tuning]
cruise_lift_scalar = 1.0
parasite_drag_scalar = 1.0
induced_drag_scalar = 1.0
elevator_effectiveness = 1.0
aileron_effectiveness = 1.2
rudder_effectiveness = 1.0
pitch_stability = 0.8
roll_stability = 0.6
yaw_stability = 1.0
elevator_trim_effectiveness = 1.0
aileron_trim_effectiveness = 1.0
rudder_trim_effectiveness = 1.0
Regards,
B24Guy