I downloaded a bunch of nice mesh files for the Himalayas and a few airports from the region. One airport that I snagged was ZUNZ which listed itself in Tibet. I then set to make some flight plans. I inputted that airport and it showed up on the list. But the sim wouldn't allow it to show in a flight plan. Sure I realize Tibet is part of China but one would think if it showed in the list it would go in a flight plan but no go. Anybody know what the problem is or how to fix it?
-
There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.
If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.
Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.
The Staff of SOH
Tibet
- Thread starter rich12545
- Start date
Without knowing exactly which addon, my first suggestion would be to check the documents that came with it and contact the author.
I was just coming back to report I figured out a workaround. I really think the problem is fs9 and not the scenery.
What I did was go into FSDiscover and make a couple of flight plans. I saved them each and was then able to open them inside fs9 to get the route with the altitude. Problem solved.
What I did was go into FSDiscover and make a couple of flight plans. I saved them each and was then able to open them inside fs9 to get the route with the altitude. Problem solved.