• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

Understanding ConvergeDistance

65olschool

65olschool

SOH-CM-2025
Hello All,
Can somebody please confirm that the ConvergeDistance="300" entry in the gunstation entry in a xdp is for multi-barrel guns and is the point the rounds would converge (if the noise value in the gun xdp was 0)?
Also is the "300" value as shown in this case metres?
And finally in the case of single barrel guns should the value should be 0?

Thanks

Mick
 
Scratch that I found it in the Aircraft Damage Profile SDK document

FYI
[h=3]ConvergeDistance[/h]Type: Floating point, meters
Default: “300”
The distance ahead of the aircraft at which the bullet stream should cross the aircraft centerline. If set to zero this value has no effect; it should always be set to zero for trainable guns.

Mick
 
You must log in or register to reply here.
Back
Top