Unusual problem with CH Yoke and Quadrant

[AussieMan]

Until about last Wednesday my CH yoke and quadrant worked fine with P3D V3.2. However late Wednesday night something happened that made it stop working. Usually all my forums open automatically but on Wednesday night or Thursday morning I had to sign in to all of them again.

No skin off my nose for having to do that but the killer was when I started P3D. Neither the yoke or quadrant would work. But the strange thing is both yoke and quadrant work in both FSX and FSX-SE.

I am at my wits end trying to work out what has gone wrong. Even been to the CH Products page and downloaded some manuals and controllers but nothing has worked. A question in the FAQ section asked if drivers were updated for W10 and the answer was no drivers were needed.

 

[Daveroo]

Wednesday night here in Cali,my win10 updated.i havent even tried to use any of my controls for any thing.....hmmm now im worried.......sorta..lol...

 

[AussieMan]

Dave, fortunately as a Microsoft Insider I still have control over my updates and can choose what I install or leave. I did an update to W10 build 14295 yesterday. I have done a re-install but still no luck.

 

[jonny]

I am very intrested in howe you solved this problem as I have both the CH trottle and yoke my self. But no problem so far.
As the yoke and throttle works in FSX the OS must have them detected?
But for P3D do you use FSUIPC? If so does FSUIPC detect yoke and Throttle?

Cheers
Jonny

 

[Stickshaker]

I don't have this equipment, but would re-installing the software work? I seem to remember it helped me with my Warthog.

 

[AussieMan]

I paid a visit to the LM Forums and discovered that my problem is not unusual. It appears to be a built in problem with P3D V3.**. Hopefully I have found the answer to my problem.

For those who may experience a similar problem here is the link to the problem:

http://www.prepar3d.com/forum/viewtopic.php?f=6315&t=113601

 

[jonny]

I am using FSUIPC payware version and my CH yoke and throttle works perfekt via FSUIPC.
You have to follow the instruction in the previous link to be succesful.

 

[AussieMan]

I am using FSUIPC payware version and my CH yoke and throttle works perfekt via FSUIPC.
You have to follow the instruction in the previous link to be succesful.

Exactly what I am doing.

 

[jonny]

Exactly what I am doing.

And still not working?

 

[Clutch Cargo]

What I have noticed a lot with P3Dv2.2 is I am losing my Saitek switch panel and BIP panel whan I switch aircraft and can only get them back by starting P3D over. Even unplugging and re-plugging the USB will not work. Don't recall having any issue with Saitek for years. I use SPAD and FSUIPC to control them. Never had issue with the yoke or pedels so far. This is on Windows 7.

 

[AussieMan]

And still not working?

Getting things back to working order. Just progressing slowly. Got most of the controls I use mapped and working. Just working on the range of movement for the TPM levers.