• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Virtavia Sea King in P3DV4

Navy Chief

Navy Chief

Senior Member
I have the Virtavia Sea King for P3D installed, and it looks/flies good enough. But what did Virtavia change to the model to work in P3D from FSX? Reason I ask is, for example, I find that (except for lighting), very few switches are clickable. NC

Also...is there any way to get the rotors to completely stop?
 
I haven't noticed any changes to the VC, I'm running the FSX version in P3Dv4.5. I can get the rotors to stop with the increase collective trick since the rotor brake doesn't work. I did notice a contact point issue as the helo will slowly turn (yaw) while on the ground.
 
N. C., sorry for asking the dumb question, but did you try to set the throttle lever to the up level after decrease the engine power? That's the way I can get my rotors to stop...
 
You must log in or register to reply here.
Back
Top