• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

Visual Model Error

falcon409

falcon409

SOH-CM-2025
I just finished installing the Hawker Sea Fury FB11 by David Hanvey and Paul Barry. I did the update and then installed a new upgrade V2.3 by Peter Forster.

What I get, every time I try to select one of the variations is an error message that says the visual model cannot be displayed. Does anyone know under what circumstances I would get a message like that?
 
It is I think a old Fs 2000/CFS2 model and will not work in FSX that is the common message to say the model is the wrong format.

I have never got it into FSX.
 
Yep, that appears to be some nice early modeling, but I don't think that one is going to be done anytime in the next century, lol. I know there's another that's been released depicting the "Spirit of Texas", which is hangared about 2 miles from me here in North Texas, but it didn't get very good revues and it's only the Race version.

Looks the Sea Fury is one I can cross off my list for FSX. Thanks Rich.:salute:
 
I tried that model into my FSX just some weeks ago.
I installed some updates but not the last one you mention. The model worked, unfortunately it had a display issue with the prop. Instead of the typical transparency prop and dissapearing clouds behind prop that we all know with port-overs, this one had a dissapearing PLANE behind the prop !

That is that if you would look at the plane in external front view, you would simply not see the plane body, just the wings. Only when looking from aside you could see the plane.
EDIT: of course, when switching the engine OFF and the prop is not spinning anymore, there are no issues anymore... but it gets hard to fly :D

Too bad though, it was a very beautifull model...
 
You must log in or register to reply here.
Back
Top