• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Ezdock and Simmconnect time outs

ejoiner

ejoiner

Charter Member
Hi. I use and love ezdock view system. however, during the (long) start up cycle of P3D, I get a time out from simconnect that requires me to click a dialog box telling the system to continue to wait. The dialog box says i should run the config tool. I do that but it never makes a difference.

If I click OK and the sim continues to boot up, then no problem, all still works well, though sometimes I get the same pop up dialog box in the background during game play.

This hasnt interrupted EZCA from working, but its annoying. is there a way to make this stop?
 
ejoiner said:
Hi. I use and love ezdock view system. however, during the (long) start up cycle of P3D, I get a time out from simconnect that requires me to click a dialog box telling the system to continue to wait. The dialog box says i should run the config tool. I do that but it never makes a difference.

If I click OK and the sim continues to boot up, then no problem, all still works well, though sometimes I get the same pop up dialog box in the background during game play.

This hasnt interrupted EZCA from working, but its annoying. is there a way to make this stop?
Click to expand...

So...

Crickets.

Nobody has this issue? please point me toward a resource to answer this.
 
Hi, Eric,

I've had this problem for quite some time. It's gotten so bad that I don't load EZCA automatically. I wait until P3D is running and my aircraft is loaded and sitting on the tarmac, and then I load EZCA by double-clicking on a shortcut on my desktop.

I looked through all the advice on the simforum EZCA forum and tried everything, but doing as I do above is the only way to avoid the time-out issues I was experiencing.
 
JRMurray said:
Hi, Eric,

I've had this problem for quite some time. It's gotten so bad that I don't load EZCA automatically. I wait until P3D is running and my aircraft is loaded and sitting on the tarmac, and then I load EZCA by double-clicking on a shortcut on my desktop.

I looked through all the advice on the simforum EZCA forum and tried everything, but doing as I do above is the only way to avoid the time-out issues I was experiencing.
Click to expand...

That is EXACTLY what I do now as well. I just load P3D in windowed mode. double click the EZCA icon then hit ALT+ENTER to go full screen. Works fine.
 
You must log in or register to reply here.
Back
Top