Last night I had the urge, so I bought the Alphasim Skywarrior despite the fact that it's a portover. It's actually a pretty nice model for it's age. Unfortunately I have to turn off DX10 when I use it because my textures turn all white. I'm sure this question has been asked a trillion times, but is there a way to get rid of the white?
-
Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.
Is there a way to get rid of white textures with DX10?
- Thread starter djscoo
- Start date
falcon409
SOH-CM-2026
Two ways, both of which you've probably already figured out:
1. If you must run DX10 don't fly port overs
2. If you insist on flying port overs, turn off DX10
Pretty simple really, lol. Actually I have found a few port overs that aren't affected by the DX10 technology, but not many. It's the price we pay I guess, and actually I haven't seen much while flying with DX10 that makes me want to just drop everything and start preaching the wonders of DX10.
1. If you must run DX10 don't fly port overs
2. If you insist on flying port overs, turn off DX10
Pretty simple really, lol. Actually I have found a few port overs that aren't affected by the DX10 technology, but not many. It's the price we pay I guess, and actually I haven't seen much while flying with DX10 that makes me want to just drop everything and start preaching the wonders of DX10.
I get the same, some portovers shw up fine, and others are all white. I don't see any visible difference other than water in DX10, but framerates are around 15-20 fps slower a low altitudes in DX9 for me. Once I get above 6,000 ft or so I can't tell the difference...I like to fly under the radar though.
