• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

BladeSlapSND and Prepar3D

You might need that gaugesound.DLL in P3 to get it to work. Also, I wonder if you need FSUIPC? I dont know, but just some possible things to try out.
 
Nothing yet. I downloaded the latest dsd_xml from Doug Dawson's website, and still it's a no go.
 
Hi Bill.
I followed the directions to the letter.

1. Extract / Copy folders into FS

The 2 folders „GAUGES“ and „SOUND“ contained in this package have to be extracted into the
main FS-directory. You can check, that everything went right if you can see a sub-folder
BladeSlapSND inside the Gauges and the Sound-Folder of your Flightsimulator installation. Looks
like follows:
… FSX main direcory … \Sound\BladeSlapSND
… FSX main direcory … \Gauges\BladeSlapSND

2. Edit your Panel.CFG

After installing the files, you have to add a configuration in each Panel.cfg (of the helicopters you
which to add the effect). Add the following 2 lines as described below. The second line depends on
the helicopter-type:
gaugexx=dsd_fsx_xml_sound!Sound, 2,2,2,2,./Sound/BladeSlapSND/Sound-Config.ini
gaugexx=BladeSlapSND!EC135-SLAP, 3,3,3,3


dsd_fsx_xml_sound.gau, and dsd_fsx_xml_sound.ini are both in the Gauges/root folder.
I have also tried both those files in the;
-Gauges/BladeSlapSND
-and Sound/BladeSlapSND folders.
 
You must log in or register to reply here.
Back
Top