Thanks to Manuele Villa's paint kit and using a photo and profile from the Winsock DATAFILE 130 on the single-seat S.V.A. 5 fighters, I did an Argentine S.V.A.5. This represents one of 17 Argentine SVA 5s, all of which carried the stand Ansaldo factory finish (including the Red and Green wing tips), with the Argentine roundel in the standard fuselage position and the national flag on the rudder. They were marked in the fuselage sides with white numbers from 1 onwards.They were operated by the Escuela de Aviacion Militar sited at El Palomar Air Base near Buenos Aires. Caz.
Note: This package contains the following update: These are all fuse2_t.bmp textures. I made the mistake when using my Photoshop textures of leaving in the S.V.A. 9 wood textures on all and the Vickers on three. These textures correct the errors. Simple open your FS9 > Aircraft > Ansaldo SVA5 MVG and replace the old fuse2_t.bmp textures in the appropriately named folder. Also, please read my Read Me. There are some changes that need be made to the aircraft.cfg. for the proper model to show up. I just figured out the proper model naming for the top wing tanks on Manuele's aircraft and altered the proper model and panel names in the aircraft.cfg. for each repaint that required a change. Sorry for this hindrance, but I caught the problems and I am a bit of a perfectionist, so I fixed them. Caz.
By Cazzie, 2008-09-22 19:34:40
By Cazzie, 2008-09-21 13:25:55
Note: This package contains the following update: These are all fuse2_t.bmp textures. I made the mistake when using my Photoshop textures of leaving in the S.V.A. 9 wood textures on all and the Vickers on three. These textures correct the errors. Simple open your FS9 > Aircraft > Ansaldo SVA5 MVG and replace the old fuse2_t.bmp textures in the appropriately named folder. Also, please read my Read Me. There are some changes that need be made to the aircraft.cfg. for the proper model to show up. I just figured out the proper model naming for the top wing tanks on Manuele's aircraft and altered the proper model and panel names in the aircraft.cfg. for each repaint that required a change. Sorry for this hindrance, but I caught the problems and I am a bit of a perfectionist, so I fixed them. Caz.
By Cazzie, 2008-09-22 19:34:40
By Cazzie, 2008-09-21 13:25:55
