• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

A2A P-47 problems...

A

anj4de

Members +
Hello everybody

I just recently re-started FSX again after a long summer season of outdoor RC flying. Had some troubles remembering the keyboard commands at first...but now it's ok again. I have a problem though...when I was starting the A2A P-47 Akku Sim first, it was itting on the runway of PAFE, my favorite starting point, and the engine wouldn't except throttle input. After playing around and clicking here and there the P-47 rolled off the runway and crashed! The next time I started it all of a sudden the landing gear was already retracted...and the bird fell on the runway...and the program rebooted. That now happens all the time when I start the P-47. I just can't figure out how to get her back onto the legs at program start. Anybody have an idea?

thanks
Uwe
 
Uwe:

You can re-configure the A2A P47 to its original "fresh install" settings if you go to Microsoft Flight Simulator X\A2A\P47 folder and DELETE (or if you prefer, rename) all of the following files:

P47D20log.dat
P47D22log.dat
P47D23log.dat

(Once deleted, they will be re-created once you load each P-47 model in free flight.) Apparently, these files can become corrupted over time, and this clears them out. Note: TRY AT YOUR OWN RISK.

If that doesn't do it, then you should uninstall and reinstall both the aircraft and accusim, as well as any patches. Good luck.

Major V
 
You must log in or register to reply here.
Back
Top