• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

AH/JF Lancaster MkBI parameters

WarHorse47

WarHorse47

SOH-CM-2024
While revisiting the AH/JF Lancaster I noticed that there are three parameters for different model configurations.

I've figured out that H2S is for the radar dome and FG is for the engine exhaust flame guards, but haven't figured out what the LP parameter configures? Anyone know what the LP parameter does?

There's no reference in the manual or other text and so far I've not received any response in the JF forum.

Thanks in advance.
 
Just guessing here, don't have her installed at the moment, but have you checked the prop blades? The Lanc came equipped with needle or paddle blades.

The only thing I can see in the manual is the mention of the Lancaster Prototype?
 
Good guess. I'll have to take a closer look at the prop blades.

Based on my entries, four of the original textures and five addon textures have the LP parameter. Some addon repaints have no parameters so I may research their accuracy and add the parameters as needed.

UPDATE: The LP parameter doesn't seem to change the prop in any way. I just compared two screenshots and couldn't see any difference between the models with or without the parameter.
 
My FS9 version has different callouts. Due to poly restrictions there are different models for different VC variations, with different stations modelled depending. But the exterior model callouts vary from yours.

Apart from the vanills there is.
.Bulge - bulged bomb bay
.HS2 - same as yours
.UPKEEP - Dambuster
.Grandslam - obvious
.AeroNavale - French variant
.prototype - obvious

This excludes the Radial engined version also.

Not clear but may give you a clue. The prototype would be my guess. Possibly look for a ventral turret?
 
Has anyone ever done a Lanc MkII (radial engine)? Practically all were operated by No. 6 (Canadian) Group.
 
Got a response from Aeroplane Heaven

The LP stands for lower pitot. Armchair experts of the day were adamant there wasn’t one and wanted it removed. Other armchair experts were equally vocal that it did. Stuck between a rock and a hard place we made it so that if you dont think it had one then you can remove it, if you did think it had one then you can still have it. One less thing to worry about in this world !
Click to expand...

Works for me. :biggrin-new::biggrin-new:
 
WarHorse47 said:
Got a response from Aeroplane Heaven



Works for me. :biggrin-new::biggrin-new:
Click to expand...
Probably an instance of they're both right depending on what plane you're looking at. Probably similar to how the Liberator's pitot tubes moved farther up the side of the fuselage and back from the D onwards.
 
You must log in or register to reply here.
Back
Top