• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Alphasim F-4 pack II VC eyepoint

L

Lenny

Charter Member
Hi,

Is there an way to set the viewpoint in the VC (an bit) higher, in the aircraft.cfg?

As it is now...I feel like an 12 year old kid sitting in the seat, and can nearly look over the aircraft nose.
 
This applies for basically every FS2004/FSX aircraft:

Open the Aircraft.cfg file, then locate this section:

[Views]
eyepoint=18.035, 0.000, 3.200

The last of the 3 values defines the vertical offset = 3.2 feet

Increase the vertical offset with e.g. 0.3, save and start a flight to see if it is OK.
If not, adjust the vertical offset further till you are satisfied.

Sometimes playing a bit with the 1st value (longitudinal offset) may also help, increase it slightly to move the eyepoint forward.
 
phantom

if i remember well the gib had the same prob in real life, they were never good for vfr lol
ex f4 driver :cost1:
 
You must log in or register to reply here.
Back
Top