• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

ATR 42/72 Logitec Throttle problem

Bushpounder

Bushpounder

SOH-CM-2024
Is anyone else having problems using a Logitec throttle (the one with three levers and three buttons - USB powered) on the new ATRs? When I configure mine, it all goes well until the throttle is retarded to the stop detent, which it bypasses and goes into reverse. I have tried everything I know of to get it to not do that, but it is useless. Also, when shutting down, I can't! I cannot cut the fuel to the engines. I can move the levers forward and aft, but cannot press the cut off buttons. Any fixes, or anyone else having this problem? First plane in this sim to give me a problem. I have used this throttle for years now, and never had a problem using it. Love the plane, but need to fly it improperly until I get these two items resolved. I did post the the MS forum, but who knows what that will do. Thanks for any help.

Don BP;)
 
Select NO reverse on Throttle- then calibrate stops/notches... all in the EFB.

Prop axis controls Condition, but you need Feather 1 and Feather 2 for Cutoff- not worth it to me- my Turboprop profile uses NO axis- and I use the mouse.

YMMV

Carl
 
Thanks, Carl. I will try that. I can live w/o reverse, but would like to have it. Can't understand why this is the only one I have run into that acts like this. I appreciate the help.

Don BP;)
 
Don-

Once the above is sorted- add F1 (with slow repeat) and F2 to buttons and you will have reverse working also.

C
 
You must log in or register to reply here.
Back
Top