HouseHobbit
Charter Member
Is it just me??
The Guns on my right wing of the Beaufort aren't firing>>:ques:
The Guns on my right wing of the Beaufort aren't firing>>:ques:
Beauforts didn't have guns in the starboard wing!
Thanks Rob, and ALL..Hi Guys,
more beauforts are coming, we have models and textures just need a bit of FM tweaking and histories etc finalised.
Owen, once the Australian built MkV and MKVIII's came out they had guns in both wings, but I believe they only saw service in the PTO after 1943.
regards Rob.
Hi Guys,
more beauforts are coming, we have models and textures just need a bit of FM tweaking and histories etc finalised.
Owen, once the Australian built MkV and MKVIII's came out they had guns in both wings, but I believe they only saw service in the PTO after 1943.
regards Rob.
Hi Guys,
more beauforts are coming, we have models and textures just need a bit of FM tweaking and histories etc finalised.
Owen, once the Australian built MkV and MKVIII's came out they had guns in both wings, but I believe they only saw service in the PTO after 1943.
regards Rob.
Could you find a way to add the front gun view?
anybody noticed that putting 100% of fuel in the loadout only registers at 80.5% on the fligth data
Doubt that will happen. Lost the final versions of this plane in HD crash (though 99% of backed up) so I would have to apply several fixes across several a/c .
Yup, that was addressed earlier in this thread. I assume its a flight model issue.
Thanx for your input:salute:
I noticed that there must have been a legacy entry in the air file that I noticed a few days ago ( and did not when I made it) that has an external fuel entry that has about 19% of the total fuel load. Not sure if this is it but makes sense. I never placed these in any air previously as when you make a drop tank you have a fuel capacity figure in the xdp that is added to the plane when the tank is mounted. I will remove this and adjust the fuel loads as needed to get it correct. Will send the revised file to Steve for his use (upload) unless I hear otherwise.
I noticed that there must have been a legacy entry in the air file that I noticed a few days ago ( and did not when I made it) that has an external fuel entry that has about 19% of the total fuel load. Not sure if this is it but makes sense. I never placed these in any air previously as when you make a drop tank you have a fuel capacity figure in the xdp that is added to the plane when the tank is mounted. I will remove this and adjust the fuel loads as needed to get it correct. Will send the revised file to Steve for his use (upload) unless I hear otherwise.