Big Creek, Wilson_Bar and Dixie_USFS

falcon409

falcon409

Moderator
Staff member
Those are the last ones to upload, which I hope to do this weekend. That will conclude the Back Country Strips for now. I plan on doing some flying for awhile. Just an FYI, Dixie USFS is not Dixie Town. I looked at Dixie Town Airport, but decided I didn't want to do the "Town", lol. . .so Dixie was the simplest and it's a nice little strip.
 
Many thanks falcon409!!!
Can't wait to try them...
Is there a possibility for you to reproduce Selway lodge airstrip located 1 mile north of Shearer USFS airstrip (2U5)?
Cheers,

Stéph.
 
Is there a possibility for you to reproduce Selway lodge airstrip located 1 mile north of Shearer USFS airstrip (2U5)?
Cheers,
Stéph.
Click to expand...

I am looking into it but I won't promise anything. it sits in an area along the river where elevations are all over the place. It may not be feasible to set the river at one elevation, and the area of the Lodge on another and have those two elevations play well with one another.
 
Big Creek installed just fine into my setup, which is stock scenery. I do still have the Orbx free airports installed because I think the immersion factor for secondary airports is greatly enhanced. No problem are noted. I'll try the other ones again, but I did have the elevation problems mentioned when they were first introduced. Thanks for your hard work and artistry Ed.
 
I have eliminated Selway Lodge Airstrip. For someone who is adept at manipulating mesh. . .sculpting, if you will, it might be doable but that's not what I do. The four backcountry strips are all I plan at this time. Time to go flying!
 
You must log in or register to reply here.
Back
Top