• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Both props spin when starting engine

B

Bill Kestell

Charter Member
HELP!

I have been playing with C46CHL using several different airfiles. Problem is that when you hit "E" ... both port and starboard props begin spinning ... with port starting up .... then starboard starting up ... but remember ... when you hit "E" ... BOTH PROPS BEGIN SPINNING.

Now, can anyone direct me as to where I have to go and into which file to kill the spin on the starboard prop UNTIL THE DAMNED THING IS ACTUALLY STARTING UP?

GEEEZE .... this thing is gonn'a make me nutz or kill me!:banghead:

Thanks, Billy
 
Bill, have you tried using the prop parameters from the stock C47 air file yet---copy/pasting from A to B? You'll need to focus on records 510, 511 and 512.
 
I have come across some models that have the prop animations set up to have both props spinning at the same time...even with one engine shut off, both props will spin at what ever RPM the throttle is set at. I hope this is not the case with your plane, Bill.

OBIO
 
props

To stick my oar in - it sounds like it's in the mdl file - you'd need the source file to correct it ( is it FSDS2 ? )

baldy
 
You must log in or register to reply here.
Back
Top