• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

C-47 prop control problem

F

flyingboxcar

Members +
I am using MJ's C-47 and C-117 in P3D with very good results except that the engine control levers are very difficult to get setup. I am using the CH Products Throttle Quadrant and a registered version of FSUIPC to set them up. They are very prone to vibrating and chatter with the Prop Control being the worst. I have tried and tried using various "Slope" patterns, but can't seem to get them set. They jump from full forward to feather in an instant. I tried a search in the forum for this problem, but didn't get any result, so forgive me if this has been discussed before. Has anyone else had this problem and how did you solve it?
Thanks.
Howard
 
Not sure this is it, however I also have a CH Pro Throttle (single throttle) as well as a joystick which has a small lever that is also assigned to the throttle, so in some aircraft, they conflict (the animated throttles jump back and forth). I had to assign the joystick lever to the prop pitch function and leave the CH throttle as mapped and the jumpiness was gone.
 
No I have a registered version of FSUIPC but I don't really use it for much of anything really. All my control mapping is done in the sim.
 
You must log in or register to reply here.
Back
Top